2W audio Amplifier

 2W audio Amplifier

Device purpose:

This amplifier was designed to be self-contained in a small loudspeaker box. It can be

feed by Walkman, Mini-Disc, iPod and CD players, computers and similar devices fitted

with line or headphone output. Of course, in most cases you will have to make two boxes to obtain stereo.

Parts:
P1_____________10K Log.Potentiometer
R1,R2__________33K 1/4W Resistors
R3_____________33R 1/4W Resistor
R4_____________15K 1/4W Resistor
R5,R6___________1K 1/4W Resistors
R7____________680R 1/4W Resistor
R8____________120R 1/2W Resistor
R9____________100R 1/2W Trimmer Cermet
C1,C2__________10μF 63V Electrolytic Capacitors
C3____________100μF 25V Electrolytic Capacitor
C4,C7_________470μF 25V Electrolytic Capacitors
C5_____________47pF 63V Ceramic Capacitor
C6____________220nF 63V Polyester Capacitor
C8___________1000μF 25V Electrolytic Capacitor
D1___________1N4148 75V 150mA Diode
Q1____________BC560C 45V 100mA PNP Low noise High gain Transistor
Q2____________BC337 45V 800mA NPN Transistor
Q3____________TIP31A 60V 4A NPN Transistor
Q4 ___________TIP32A 60V 4A PNP Transistor
SW1___________SPST switch

SPKR__________3-5 Watt Loudspeaker, 8, 4 or 2 Ohm impedance


The circuit was deliberately designed using no ICs and in a rather old-fashioned manner in
order to obtain good harmonic distortion behavior and to avoid hard to find components.
The amplifier(s) can be conveniently supplied by a 12V wall plug-in adapter.
Closing SW1 a bass-boost is provided but, at the same time, volume control must be increased to compensate for power loss at higher frequencies.
In use, R9 should be carefully adjusted to provide minimal audible signal cross-over
distortion consistent with minimal measured quiescent current consumption; a good
compromise is to set the quiescent current at about 10-15 mA.
To measure this current, wire a DC current meter temporarily in series with the collector
of Q3.

Technical data:

Output power:

1.5 Watt RMS into 8 Ohm, 2.5 Watt into 4 Ohm, 3.5 Watt into 2 Ohm (1KHz
sinewave)

Sensitivity:

100mV input for 1.5W output @ 8 Ohm

Frequency response:

30Hz to 20KHz -1dB

Total harmonic distortion @ 1KHz & 10KHz:

<0.2% @ 8 Ohm 1W, <0.3% @ 4 Ohm 2W, <0.5% @ 2 Ohm 2W